Arduino Uno Tilt Sensor

This project demonstrates how to use a tilt sensor with an Arduino Uno to detect orientation changes.

It reads the state of the tilt sensor and displays the status via the Serial Monitor.

Components Needed

Connect the signal pin of the tilt sensor to digital pin 2 on the Arduino Uno.

Connect the VCC and GND of the tilt sensor to the respective power and ground pins on the Arduino Uno or an external power supply.

Wire up the tilt sensor to the Arduino Uno as per the circuit setup section.

Open the Arduino IDE and create a new sketch.

Copy and paste the provided Arduino code into the sketch.

Upload the code to the Arduino Uno.

Open the serial monitor with a baud rate of 9600.

Tilt the sensor module and observe the state change in the Serial Monitor.

Ensure the tilt sensor is securely mounted and calibrated for accurate detection.

Adjust sensitivity or debounce techniques for reliable tilt detection in specific applications.

Explore using multiple tilt sensors for more complex orientation sensing tasks.