Arduino Uno Hit Sensor Module

This project demonstrates how to use a hit sensor module with an Arduino Uno to detect hits or taps.

The sensor's digital signal is read by the Arduino, and when a hit is detected, a message is displayed on the serial monitor.

Block Diagram

Connect the hit sensor module to the Arduino Uno as described in the circuit setup section.

Open the Arduino IDE and create a new sketch.

Copy and paste the provided Arduino code into the sketch.

Upload the code to the Arduino Uno.

Open the serial monitor with a baud rate of 9600.

Tap or hit the sensor module and observe the serial monitor output displaying the hit detection message.

Ensure the hit sensor module is correctly connected to the Arduino Uno and powered.

Adjust the code logic and threshold for hit detection based on your specific sensor and project requirements.

Add additional features to the code to respond differently based on the intensity or frequency of hits detected.