Color Sensor

The Color Sensor project utilizes an Arduino Mega to interface with a color sensor module and detect RGB (Red, Green, Blue) components of light. This project demonstrates how to configure the color sensor, select different color filters, and read RGB values using Arduino. It's an essential project for applications requiring color detection and analysis, such as color sorting, ambient light sensing, and color-based identification systems.

Components Needed

• Arduino Mega
• Color Sensor Module
• Jumper Wires
• Breadboard
• Power Supply

Block Diagram

Circuit Setup

Connect the Buzzer to Arduino Mega:

Instructions

Install Required Libraries:

No additional libraries are required for this project.

Circuit Setup:

Connect the color sensor module to the Arduino Mega as specified in the circuit setup section.

Code Upload:

Open Arduino IDE and create a new sketch.

Copy and paste the provided Arduino code into the sketch.

Testing:

Upload the code to the Arduino Mega.

Open the serial monitor in Arduino IDE to view RGB values detected by the color sensor.

Applications

Notes

Ensure proper wiring and connections to prevent signal interference or incorrect readings.

Adjust the frequency scaling (S0 and S1 pins) based on specific application requirements for color detection.

Calibrate the color sensor module if precise color measurements are necessary for particular applications.